Loglift 96S CE - Page 49

To Next Page

To Previous Page

NOTE

To operate the crane with the controller, press and hold the button (2) at the same

time,

CAUTION

Keep the remote control away from water. Store it inside the cabin when it is not

used.

The control system TimberTronics [option]

Loglift 96S CE 49

Main Page

Table of Contents3
Introduction7
This Operator's Manual Is Intended for the Operator of this Loglift Crane7
Cleanliness Certificate7
The Machinery Directive 2006/42/EC8
Description of Loglift 96S9
Indications in the Operator's Manual9
Identification of this Crane11
Structure and Parts of the Crane12
Main Groups12
Crane Base with Column and Slewing System12
Boom System and Add-On Lifting Accessories12
Stabiliser System13
Operating System - Hydraulic Components13
Buttons on the Control Panel [Option]14
Premium High Seat [Option]14
Cabin [Option]15
Control Panel in the Cabin C91215
Control Panel in the Hi-Cab16
Fuses in the Cabin C91217
Fuses in the Cabin Hi-Cab17
Main Control Valve18
Stabiliser Control Valve18
Safety Precautions and Warnings20
Operating Conditions20
Wind Speeds21
Noise Declaration21
Signs on the Crane22
Maximum Load22
Signals When Using a Crane23
Use of the Crane27
Use of Lifting Equipment33
Use of Dismountable Cranes34
The CE System [Option]36
How the CE System Works36
Components in the CE System36
Buttons and Indicating Lights on the Interface37
Manual Control System [Option]39
Operation from the High Seat39
Manual Operation from Cabin40
HPC [Option]41
The Control System Timbertronics [Option]42
The Timbertronics Control System42
Components in the Timbertronics System42
Display43
The Control System Multidrive2 [Option]50
The Control System Multidrive250
Components in the Multidrive2 System50
Multidrive2 Control Levers and Display50
Buttons and Indicator Lights on the PDF53
Starting Crane Operation55
Starting Operations55
Attach the Crane to the Vehicle55
Electric Tiltable Seat [Option]56
Extend Stabiliser Extensions and Set Stabiliser Legs57
Stabiliser System and Ground Conditions58
During Operation60
Operate the Crane60
Slope Control [Option]61
Adjust the Speed of each Function for Timbertronic Control System61
Ending Crane Operation62
Placing the Stabiliser System in Transport Position62
Electric Tiltable Seat [Option]64
Ending Use64
For Cabins [Option]66
Warning Interface (TWI)67
Remove the Crane from the Vehicle (Console Mounted)67
Emergency Operation of the Dump Valve68
Maintenance and Service69
Warranty69
Service69
Follow the Maintenance Instructions70
Daily Inspection71
Additional Daily Inspection for the Cabin (if Installed)72
Weekly Inspection and Maintenance72
Additional Weekly Inspection and Maintenance for the Cabin (if Installed)73
Monthly Inspection and Maintenance73
Additional Monthly Inspection and Maintenance for the Cabin (if Installed)74
Twice a Year Maintenance75
Annual Maintenance75
Additional Annual Maintenance for the Cabin (if Installed)76
Lubrication76
Lubrication77
Lubrication of the Upper Column Bearing77
Lubrication of Ball Joints in Cabin78
Clean and Grease the Spring Cups78
Adjust the Lateral Clearance of the Boom And/Or Hydraulic Extension79
Adjust the Chain in the Telescope79
Cabin [Option]80
Adjust the Slide Pads in the Cabin80
Tightening of Screws and Bolts in Cabin80
Windshield Wiper Fluid81
Change Wiper Blade81
Replace Leds on the Control Panel82
Change the Air Filter82
Hydraulics83
Crane Base: Checking the Oil Level/Oil Change83
Bleeding Air from the Hydraulic System83
Replacing the Cartridge in Return Oil Filter84
Replacing the Cartridge in High Pressure Filter85
Checking the Oil Tank Level86
Changing the Hydraulic Oil86
Troubleshooting88
Faults in the Crane88
Faults on the CE Device89
Diesel Heater [Option]91
Technical Data94
Load Plate Table94
Decommissioning95
Decommissioning a Crane95

Loglift 96S CE - Page 49

Table of Contents

Related product manuals