1.1.3. Description of Loglift 96S
The Loglift 96S is manufactured by Hiab to load cut-to-length timber with a grapple. Usually
installed on a timber truck, either in the rear or behind the cab, it is not intended for hook duty .
The Loglift 96S is available in many versions with a wide range of accessories, and fulfills the
requirements of the European Machinery Directive as specified by the standard EN12999.
On the serial number plate, you can find information on the crane type and on the manufacturer.
NOTE
The exact technical information for your crane is shown in "Technical Data".
1.2. Indications in the Operator’s Manual
What must you do and not do?
The following indications are used in the Operator’s Manual:
DANGER
Danger to life for yourself or to bystanders.
Follow the instructions carefully!
WARNING
Danger of injury to yourself or to bystanders, or danger of serious damage to the
crane or other objects.
Follow the instructions carefully.
CAUTION
Hazard for the crane or crane components. Follow the instructions carefully.
Important:
If actions are numbered
1. Do this
2. Do that
3. ......
4. .....
5. .....
you should carry them out in numerical order!
NOTE
Extra information that can prevent problems.
Introduction
Loglift 96S CE 9
To Next Page
Loading...