Lombardini 11 LD 626-3 - Registration of Modifications to the Document; Preface

- 2 -
11 LD Workshop Manual_cod. 1.5302.296_5° ed_ rev. 04
CUSE/ATLO
30.07.20075° 4
PREFACE
- Every attempt has been made to present within this service manual, accurate and up to date technical
information.
However, development on the LOMBARDINI series is continuous.
Therefore, the information within this manual is subject to change without notice and without obligation.
- The information contained within this service manual is the sole property of LOMBARDINI.
As such, no reproduction or replication in whole or part is allowed without the express written permission of
LOMBARDINI.
Information presented within this manual assumes the following:
1 - The person or people performing service work on LOMBARDINI series engines is properly trained and
equipped to safely and professionally perform the subject operation;
2 - The person or people performing service work on LOMBARDINI series engines possesses adequate hand
and LOMBARDINI special tools to safely and professionally perform the subject service operation;
3 - The person or people performing service work on LOMBARDINI series engines has read the pertinent
information regarding the subject service operations and fully understands the operation at hand.
- This manual was written by the manufacturer to provide technical and operating information to authorised
LOMBARDINI after-sales service centres to carry out assembly, disassembly, overhauling, replacement and
tuning operations.
- As well as employing good operating techniques and observing the right timing for operations, operators must
read the information very carefully and comply with it scrupulously.
- Time spent reading this information will help to prevent health and safety risks and financial damage.
Written information is accompanied by illustrations in order to facilitate your understanding of every step of
the operating phases.
1-5302-296 50510 1-891-89
REGISTRATION OF MODIFICATIONS TO THE DOCUMENT
Any modifications to this document must be registered by the drafting body, by completing the following table.
Drafting
body
Document
code
Edition Issue date
Review
date
Model
N°
Revision Endorsed