56
COMPILER TECO/ATL
REG. CODE
1-5302-296
MODEL N°
50510
DATE OF ISSUE
01.89
REVISION 02
ENDORSED
DATE
17.04.2003
147
146
145
XI
STANDARD ELECTRIC EQUIPMENT
Electric starting layout without battery charging light
Components:
1 Alternator
2 Starting motor
3 Voltage regulator
4 Battery
5 Pressure switch
6 Oil pressure warning light
7 Key switch
Electrical starting layout with battery charging Iight
Components:
1 Alternator
2 Starting motor
3 Voltage regulator
4 Battery
5 Pressure switch
6 Oil pressure warning light
7 Key switch
8 Battery charging light
Note: Battery, which is not supplied by Lombardini, should feature a
12V voltage.
When choosing battery capacity please consider environmental
conditions: 66 Ah are recommended down to -10°C and 88 Ah are
recommended below -15°C; in any case do not use a battery with
greater capacity than 110 Ah.
12,5 V, 14 A Alternator
Features a fixed armature winding, housed in the bell inside the
blower stator.
The rotating permanent magnet inductor is located in the fan spindle.
See page 17.
Dimensions (mm):
A = 111.701÷111.788
B = 31.000÷33.500
C = 76.226÷76.300
D = 77.400÷77.474
Note: Clearance between armature winding and inductor (air gap)
should be 0.55÷0.63 mm.
ELECTRIC SYSTEM
To Next Page
Loading...
