Lombardini CHD series - Engine Components; Oil-bath air cleaner; Dry air cleaner

- 27 - Workshop Manual LDW CHD _ cod. 1.5302.345 - 6° ed_rev. 05
3
2
1
4
Dry air cleaner
Danger – Attention
Never clean the ltering element using solvents with a low
ash point. This could cause an explosion !
A = Fitting to accomodate clogging indicator
See page 22 for periodic dry air cleaner check and replacement
andtherubberintakehose(airlter-intakemanifold).
Oil-bath air cleaner components
1 Bowl
2 Outer seal ring
3 Lowerlteringelement
4 Inner seal ring
5 Gasket
6 Cover
7 Cap clamp
8 Cap
9Centrifugalpre-lter
10 Centrifugalpre-lterclamp
11 Oil level mark
12 Upperlteringelement(polyurethansponge)
Note:Centrifugalpre-lter9istteduponrequest.
Oil-bath air cleaner
Danger – Attention
Never clean the ltering element 6 using solvents with a
highly ash point. This could cause an explosion !
Caution – Warning
During repair operations, when using compressed air, wear
eye protection.
Check gaskets and replace if necessary.
Checkthatangeweldsarefreeofporosityordefectivespots.
Carefully clean bowl and ltering element with Diesel fuel and
dry with compressed air.
Top up engine oil to the mark (see below).
Whenrettingtightennutsto25Nm
See page 22 for periodic cleaning and oil replacement.
Disassembly / Reassembly