Long 460 - Page 34

2. Bring throttle lever to middle of travel.
3. When the
tractor has been out of operation for a long time or when it is
started for the 1st time in cold weather, press lever 6 (fig. 13) twenty times.
4.· Place ignition key into switch to position 1 (fig. 14).
5. Fully depress starting aid button (8, fig. 12) and turn thermostarter and
ignition switch handle to position 3 (fig. 15), by hand. Immediately after
starting the engine , bring switch to position O (fig. 15).
1
I
0
Fig. 15 - Ig nition and the rmostarter
control switch
0 = OFF
1
= Thermostarter ON
2 = Thermostarter ON and engine
starting
3 = Engine starting
Fig . 14 - Ignition switch and key
0 = No circuit energized (key can be
withdrawn)
Engine starting and heating circuit
energized; turn signals and instru-
ments
ON
2 = Same as 1; plus parking lights ,
number plate light and rear flood-
light ON
3 = Same as 2; plus headlight low
beams
ON
4 = Same as 2; plus headlight full
beams
ON
5 = Parking lights, number plate light
and rear floodlight ON (key can be
withdrawn)
2 -
/
\
33