3.1 Use screwdriver to loss the screw, take out swirl pole, making sure the two pins on the
swirl pole are symmetrical.
Swirl pole
3.2 Some time, when press on the igniter button, there do not have clearly ignition sounds
like “Ta, Ta……”, or the ignition sounds is very low, not loud enough, please do following,
Hit one of the Pins a little bit, (Please only a little bit)
Grind the pin a little bit, (Please only a little bit)
If there any deposited carbon on the pins, please use copper brusher to swipe off.
To Next Page
Loading...