■ TECHNICAL SPECIFICATIONS
- Usable at any plant by easy to change input voltage 220V, 380V, 440V
- Easy to verify cutting current by digital ammeter during cutting
- Cutting with air only, no need other gas
- Non contact arc starting by pilot circuit
- No need keeping to push torch switch during cutting by turning AUTO switch On which
is on front panel of power source
ITEM UNIT 100LP 130LP 150LP
Input Voltage V
220, 380, 440
Single Phase or Three Phase
Switchable
Frequency Hz 50/60
Rated Output Current A 100 130 150
Input Current @ rated output KVA 12 23 27
No Load Voltage V 280
Output Current Range A 25 ~ 100 35 ~ 130 50 ~ 150
Output Voltage V 110 120 130
Duty Cycle @ rated output % 60
Dimension (W×D×H) mm 330×680×530 385×780×610 385×825×610
Weight kg 44 62 69
To Next Page
Loading...