To Next PageTo Next Page
Need help?Do you have a question about the LoPresti Speed Merchants BOOM BEAM and is the answer not in the manual?
General| Brand | LoPresti |
|---|---|
| Model | Speed Merchants BOOM BEAM |
| Category | Lighting Equipment |
| Language | English |
Mount ballasts to wing ribs using Click Bond studs and hardware.
Connect ballast to power and lamp/starter wires with dielectric compound.
Install the reflector/lamp assembly into the wing tip using existing hardware.
Connect ballast to lamp/starter wires and secure them with cable ties.
Connect landing light power and ground wires to the ballast.
Test light operation and verify aiming based on initial setup.
Tasks for annual/100-hour inspections: inspect integrity, fasteners, wiring, components.
Install tuning plates and gasket to adjust beam pattern between Long Range and Standard.
Detail general and specific surface preparation steps for adhesive application.
Explain how to mix pre-proportioned adhesive foil pack kits.
