LORD W1 Repair And Maintenance Information

4.2 Replacing door seal
Prerequisite:
Appliance is disconnected from power supply.
Appliance is disconnected from water supply.
Detergent drawer has been removed.
Fascia panel has been removed.
Door has been removed.→Page 57
Front panel has been removed.
4.2.1 Replacing door seal
1. Detach transmitter hose from water level controller.
2. Detach siphon from detergent dispenser and housing.
3. Detach door sear air conductor from upper air infeed of door seal.
4.
Always keep hold of bolt nuts.
Remove four screws.
5. Remove weight and front base.
4.2.2 Installing door seal
When installing the front base, ensure that the supporting surface is
clean (no pieces of concrete, ...)
▶
Install in reverse order.
Repair

LORD W1 Specifications

General

Brand	LORD
Model	W1
Category	Washer
Language	English