Place the heater on a firm level surface free from obstructions, and at least 3 ft. away from
any wall and any other objects such as furniture, curtains, plants or combustible material.
• Plug the heater into a grounded 120V outlet. The buzzer sounds, the Digital Screen
indicates current temperature.
• Press the Power button repeatedly to the desired setting. The cycle is as follows:
• High: Heater operates at a higher wattage, around 1500 Watts.
• Low: Heater operates at a lower wattage, around 900 Watts.
• Fan: The fan circulates room air only. The heating elements are “OFF”
Turning the Unit Off
Press the POWER button to cycle through the functions until none of them are lit (High, Low,
Fan).
After the unit is turned off, the fan will continue to run for 15 seconds to cool down, the
digital screen will display the process from 15 backward to 1. After the display turns off,
unplug the heater from the electrical outlet.
Set the desired temperature
• In order to set the thermostat the unit has to be on High or Low.
• When the unit is on, press the ▲ or ▼ button, the buzzer sounds and the setting
temperature flash on the digital screen.
• At this time you can press the ▲ or ▼ key to the temperature desired. (40F-95F).
• Wait for around 5 seconds until the digital screen displays the current temperature
again.
Note: If the current temperature is higher than the set temperature (95F is original set
temperature), the unit will stop heating.
Setting timer
•
Press TIMER button repeatedly to set the auto-on time within 12 hours.
Setting the heater to turn off automatically
• In order to set the unit to turn off, the unit must be on (High or Low).
• Press the Timer button, the timer setting pilot will illuminate.
• You can see “0” flashes on the digital screen.
Press TIMER button repeatedly to set the auto-off time within 12 hours.
Setting the heater to turn on automatically
• In order to set the unit to turn on, the unit must be off.
• Press the Timer button, the timer setting pilot will illuminate, and you can see “0”
flashes on the digital screen.
•
The timer indicator will appear on the digital screen after the timer is set. You can check the
remaining time of timer by pressing the TIMER button.
To Next Page
Loading...
General