Lorex VANTAGE LH110 ECO SERIES - System Menu

143
Configuring the system remotely
2 Configure the following:
• Channel: Sel
ect the channel you wish to configure motion detection.
• Motion Detect: Select Enable or Disable.
• Sensitivity: Select the desired sensitivity. The greater the number, the greater the motion
detection sensitivity.
• Type: Select Set to allow the cursor to mark the grid as a motion detection zone.
• Click the Copy button to copy the setting to multiple channels. Next, click on the channels
that you wish to apply the settings to.
3 Drag the cursor over the motion grid to select the area that will detect motion.
4 Cl
ick Save to apply your settings.
System Menu
To configure the System setting menu:
1 Cl
ick REMOTE CONFIG>System>System Setting.
2 Co
nfigure the following:
• Ti
mezone: Select the DVR’s local time zone.
3 Cl
ick Save to apply your settings.
Drag your mouse cursor to mark
areas to detect motion.
System Setting