RESIZING/CHANGING THE BRACELET
MICROADJUSTMENT
Use the round end of a
strap changing tool (not
included) to push in the
clasp springbar, then
move the springbar into
the desired slot.
Make sure it is in the
same slot on both sides
of the clasp.
SIZING WITH LINKS
Use the screwdriver to
remove and replace links as
needed.
For a secure fit, we highly
recommend applying
low-strength threadlocker,
such as Loctite 222/222MS
(not included).
CHANGING STRAPS
Use the strap changing tool
(not included) to remove
and replace the springbar.
One side at a time, insert the
round end into the lug holes
and gently pull the bracelet
so that both ends are out.
Place the springbar back
into the holes for use with
another strap. The forked
end of a strap changing tool
is also made to help with
this.
PLEASE USE CAUTION
WHEN REMOVING THE
SPRINGBAR AS IT COULD
FLY OUT
To Next Page
Loading...
