Lotus Service Notes Section BR
Page 33
6. After cutting out the screen, remove old adhesive from the windscreen frame sufficiently to leave a
consistent and flat surface for the new bond.
7. Clean the whole of the inside surface of the windscreen with a 50% solution of water and isopropanol.
Allow to dry.
8. Fit the interior mirror plinth to the inside of the windscreen using the adhesive kit and instructions sup-
plied.
9. Clean the whole of the inside surface of the obscuration band, and the bonding surface on the windscreen
frame with the wipe cleaner.
10. Apply a 25 mm wide band of Betaprime around the inside periphery of the glass. Similarly apply to the
whole of the bonding surface on the windscreen frame, and to the windscreen bottom laminated edge.
Allow to dry for a minimum of 5 minutes. If the screen is not fitted within 48 hours, the primer should be
re-applied.
11. Cut the nozzle of the Betaseal cartridge
to the dimensions shown to produce a
triangular section bead. Holding the car-
tridge vertically, extrude a bead of ad-
hesive around the screen, using the edge
of the finisher as a guide along the top
and sides, and following the centreline
of the primer band along the lower sec-
tion.
Windscreen top edge Screen centreline
Obscuration 79mm
band
Mirror position on 63mm 63mm Mirror position on
RHD offset to left LHD offset to right
b263
8 mm
10 mm
60 mm
b264
To Next Page
Loading...
