148
LIGHTING
Exterior Lighting
Light Switch
Rotate the ring on the stalk
positioned on the left-hand side of the
steering wheel.
Daytime Running Lights
These illuminate when the
ignition is in mode II or engine is
running.
Daytime Running Lights
The front and rear daytime running
lights illuminate when the ignition is
in mode II, or the engine is running
(with the light switch in any position).
They will vary in intensity depending
on the lighting option selected.
Position Lights
The daytime running lights are
also activated with the light
switch set to this position.
Use this setting to illuminate the
daytime running lights with the
ignition in modes O or I.
NOTE: If the vehicle is in ignition
position II then the daytime
running lights are illuminated
instead.
The position lamps can be switched on
in any ignition position setting.
With the engine running but the vehicle
stationary, the ring can be rotated to
from any other setting to only
illuminate the position lamps.
After driving for a short time period or
as vehicle road speed increases, the
front position lamps are replaced by
the daytime running lights.
If not already activated, the rear
position lamps will illuminate if the
tailgate is opened in low level ambient
lighting conditions.
Low Beam Lights
With the engine running or with
the ignition in position II, low
beam headlights, front and rear
position and license plate lights
are activated in this position.
This symbol is illuminated in
the driver’s display screen when
either the position lights or low
beam headlights are activated.
AUTO
The low beam headlights, position and
instrument panel lights automatically
illuminate or extinguish depending on
the ambient lighting conditions.
WARNING: The AUTO system
cannot determine the ambient
lighting conditions in every
situation, (such as mist or rain).
The driver must always ensure
that the correct exterior light
setting is selected for the current
driving environment and in
accordance with any applicable
traffic regulations.
To Next Page
Loading...
