214
1. Aim the remote control towards
the HomeLink
®
button to
be programmed and hold it
approximately 2-8 cm from the
button. Do not obstruct the indicator
lamp on the mirror.
NOTE: If problems occur with the
programming, try again whilst
increasing the distance between
the remote control and HomeLink
buttons to between 6 - 8” (15-20
cm).
2. Press and hold both the button on
the remote control and the required
HomeLink button.
3. Do not release the buttons until the
indicator lamp has switched from
flashing slowly (approximately once
per second) to either flashing quickly
(approximately 10 times per second)
or is constantly illuminated.
–The indicator lamp constantly
illuminated indicates that the pro-
gramming has finished. Press the
programmed button twice to acti-
vate.
–If the indicator lamp flashes quickly
then the device to be programmed
may have a security function that
requires the device’s programming
button on its receiver to be manual-
ly depressed.
–Test by pressing the programmed
button twice to see if the program-
ming was successful.
If you experience problems program-
ming your remote controlled item, con-
tact HomeLink
®
at HomeLink.com
Reprogramming Individual Buttons
To reprogram an individual button:
– Press and hold the button as re-
quired for approximately 20 seconds.
– Once the indicator lamp on mirror
starts to flash slowly, programming
can continue as normal as shown on
page 213.
NOTE: If the button to be
reprogrammed is not programmed
with a new unit, it will resume the
previously saved programming.
Resetting the Buttons
The buttons cannot be reprogrammed
individually. It is only possible to reset
all of the buttons at the same time.
To reset:
– Press and hold the outer buttons
(1 and 3) on the mirror for
approximately 10 seconds.
– When the indicator lamp changes
from a constant glow and begins to
flash, the buttons are reset and can
be reprogrammed.
HOMELINK
®
To Next Page
Loading...
