ELECTRICAL
EQUIPMENT
Page
M12
Windscreen (Windshield) Wipermasher Control
l.
Wiper
-
Move lever downwards until
it
locks in the first position
'1'
(A
of fig. 6) for normal wiper speed. A high speed wiper
actiori can be
selected by moving the lever down further until it locks in the second
position '2'
(B
of fig. 6). Move lever upward to the off position
'0'.
NOTE:
On right hand drive vehicles the operation
is
reversed, i.e.
switch stalk up to
'l'
nannal speed, stalk up to
'2'
high
speed and return downwards to the off position
'0'.
To 'flick wipe' the screen, lift the lever upwards
(C
of fig. 6) and hold for
the duration of the wipe. On releose the lever will
automatically cancel
and return to the off position
'0';
the wiper blade returning to its normal
parked position.
WARNING: Do
NOT
use wiper on dry screen.
2. Washer
-
To operate screen washer iets push stalk towards the steering
cniaimn
ill
nr
+lz
A!
.,l,,.-
A
h-l.t
-5
-----..:--&-l
.
-..
.----
I
.
.
--.
-
.
-
-
.
-
r.
-
. .
.
. . .
-
.
-.
,
......
.-"",,"
3.
duration will provide ample water for a normal screen wash. To improve
the
wiplng
of
the screen add
55
cc of solvent (Part
No.
A075M6110Z) to
the reservoir to help remove road dirt and grease.
Binnacle
Illumination Lamps Switch
The switch which controls the binnacle illumination
is
situated in the bottom left
-
hand corner of the left
-
hand switch panel.
A
resistor
is
connected across the switch
to set the illumination intensity to the correct level.
Door Window Operating Switches
The
door windows are operated electrically arid ore controlled by switches mounted
on the tunnel switch panel; the left
-
hand switch for the left
-
hand window and right
-
hand switch for
the
right
-
hand window. Each switch
is
a centre biassed toggle switch
and when the forward edge of the switch
is
pressed the window
is
raised and the back
edge when pressed lowers the window. Door windows can only be raised and lowered
when the ignition key
is
in either the
I
or
I1
position.
When
a
window is fully closed or opened a thermal overload becomes operative ond
switches off the power to the motor.
If
any difficulty
is
experienced in lowering or
roising the windows in extremely cold conditions,
this can be remedied by using a
ESPRIT
issw
04/78
To Next Page
Loading...
