Lotus Esprit Series - Door to Window Finishers; To Remove Internal Finisher; To Remove External Finisher

BOW
Page B58
DOOR TO WINDOW FINISHERS
TO REMOVE INTERNAL FINISHER
1.
Remove the door trim panel to which the intern01 finisher is fitted.
2. East off the finisher from the door trim panel.
TO REPLACE
1.
Apply sealant along the edge of the door. trim pariel and press on
finisher
arld refit door trim panel.
10 REMOVE EXTERNAL FINISHER
1. Remove the door trim pariel to gain access to the three fixing studs
'4
securing the external finisher. Loosen the nuts on the studs ond lift
off the finlst~er frnm the door.
2.
The rubber seal can be reploced by drilling out the 13 pop - rivets and
fitting o
new seal with pop - rivets.
TO REPLACE
1.
Apply sealant along the top edge of the door and locate the
finisher in the three slots, with washers
agairlst the nuts. Push
down on the finisher above each slot and tighten nuts, ensuring
the finisher is not distorted and the rubber seal lies against the
glass when
raised. id
2. Refit the door trim panel.
ESPRIT
Issue adns