Turn key
to
II
to
turn
on ignition, and
to
Ill against spring pressure
to
start
engine.
When engine starts,
allow key
to
return
to
position
II.
Turn back
to
I
to
stop
engine. To remove key and lock steering column, press the
button
(2) which
is
beneath
the
steering nacelle, upwards, and turn key
to
0.
Ignition
Warning
Indicator {3)
The ignition warning indicator glows red when
the
ignition
is
switched on and will
go
out
when
the
engine
is
started.
If
the
indicator glows when
the
engine js above idling speed, this indicates some
fault in
the
charging circuit
or
possibly a broken vee belt.
Investigate
the
cause and rectify
as
soon
as
possible.
Combined
side,
rear
and
headlamp
switch
(4)
Press down
to
middle position
to
switch on
the
side and rear lights, and press
to
lower position
to
raise and switch on headlights.
CAUTION:
DO
NOT operate
the
headlamps unless
the
bonnet
is
closed.
If
the
lamps are raised while
the
bonnet
is
open,
the
leading edge of the bonnet and
the
rear edge of
the
lamp pod
will
be damaged.
Direction indicators/Headlamp
Flasher
I Dip-Switch/Horn (5)
Horn: Push
the
knob towards
the
steering column
to
operate
the
horn.
Direction Indicators:
Move
lever down
to
indicate a left-hand turn, and
up
for
a·
right-hand turn. Warning lamp (6) flashes when the indicators are operating.
Indicators
will self-cancel after turning.
Headlamp Flasher and Dip-Switch: With lighting switch at headlamp position
and switch
up, dipped beams are selected. With switch away from the steering
wheel main beams are selected and warning lamp (7) illuminated.
·
Lifting switch against spring pressure flashes the main beams, raising
the
head lamps
if lights are
not
already on.
To Next Page
Loading...
Need help?
General
