5
07
1009
13
08
It is recommended that the appliance electrical
connections be tested once a year by a qualified
technician.
Run the water flow for
one minute to check for
leakage before connecting
to power.
Reattach the front cover of the heater and
secure it with 4 screws and then slide the
bottom gray cover
Connect the power cable to the terminal
block.
Caution: The heater must be grounded.
Reference figure *3 on page 4 and
Electrical diagram on page 6
When installed outdoors,
the heater must be placed in
sealed waterproof electrical
box.
Make sure that the
appliance is filled with water
before connecting power.
(Repeat step 7)
11 12
Do not install the heater where
it may be subject to direct
sunlight.
To Next Page
Loading...