Troubleshooting
8
PROBLEM ISSUE POSSIBLE CAUSE SOLUTION
Heater shut off
during use.
Interruption of main
electrical supply.
Check incoming power supply, MCB,
switches and supply cabling.
If problem persists, call your local
manufacturer for assistance.
Water ceases to
flow.
No water supply. Check if the main water line stop
valve is fully open and that there
are no other restrictions in the water
supply line.
Water temperature
varies from hot to
cold during use.
Water pressure has
dropped below min. level.
Increase hot water supply.
No hot water/Unit
is not working.
No electrical power.
Low flow rate 0.5 bar (7 psi).
Check the circuit breaker and check
voltage at the wiring block.
Clean filter screen:
1. Turn circuit breaker off.
2. Open the valve to release pressure
from the unit.
3. Turn circuit breaker on.
If you have an issue and need further assistance,
please call: 1-888-783-6082
To Next Page
Loading...