APPLYING POWER TO AOP-SP70
AOP-SP70 requires 12Vdc, 500mA power. A 12Vdc power supply is included. Connect the
stripped ends of the power supply to the 2-pin terminal block located in the far right of the pc
board marked “12Vdc”. Positive 12Vdc connects to the terminal marked “+” and negative 12Vdc
or ground connects to the terminal marked “GND”.
TLO SPECIFICATIONS
SPECIFICATIONS FOR AOP-SP70
Audio output impedance
Audio input impedance
Talkback power output
Power Input
Dimensions
Weight
Shipping Weight
1W @ 70V
12 Vdc, 500 mA
8 3/8”L x 7 3/8”W x 2 3/4”H
3 lbs 8.5 oz
6 lbs
600
600
SPECIFICATIONS (SPEAKER)
Power rating 30W max @ 167W (setting 5)
Dimensions
Frequency response
11”W x 6 5/8”H x 12 3/4”D
350Hz to 14 kHz
Input
Weight of TLO
70V constant
Voice coil impedance 8W
5 Lbs 5 oz
INSTALLATION AND OPERATING INSTRUCTIONS
Page 6 of 8
LOUROE ELECTRONICS® 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458
website: www.louroe.com e-mail: sales@louroe.com
(818)
aopsp70_ inst_3/15
Sensitivity -45 dBV/Pa
1 Pa = 94 dB SPL
Frequency Response 50 Hz to 15 kHz
Output Line Level (0 dBV, 600W @ 1kHz)
Current Drain 10mA
Supply Voltage 12 Vdc
Microphone Housing High Impact Anti-Static ABS
Dimensions 2 5/8” L x 2 1/8” W x 1 1/16” H
Weight 1.5 oz
Shipping Weight 1 lb
SPECIFICATIONS (MICROPHONE)
To Next Page
Loading...