Avoid direct sunlight on LVT flooring as it can cause fading and expansion of vinyl planks. Use window protection
Surface temperature should not exceed 155F (31.6C) from sunlight, bed bug treatment, steam mop, etc, and temperatures
should not fall below 55F (13C). Exposing product to temperatures outside the recommended range couldcause expansion of
vinyl planks. (This allowance is for floating floors only and does not apply to glue-down installations).
Products containing bleach and steam mops are not recommended.
Walk-off mats should be used at all entrances to absorb soil and moisture. If mats are placed directly on top of the resilient
floors, use mats without latex or rubber backings to avoid possible discoloration.
ROUTINE MAINTENANCE
Daily removal of dirt and dust is important to prevent particles from abrading the surface of resilient floors. Sweeping, dust
mopping, and vacuuming are recommendations to remove soil particles that can result in scratches and worn appearances. Do
not use vacuums with rotating beater bars on hard surfaces.
Periodic wet cleaning will be necessary to help maintain the floor’s appearance. Always pre- vacuum or dust mop before any
type of wet cleaning. Appropriate vinyl floor cleaning equipment and cleaning agents (neutral pH floor cleaners) are
recommended. Do not use abrasive cleaners or cleaning agents that leave dull residues on the surface of the floors. Follow the
cleaning manufacturer’s instructions for damp mopping and application. If rinsing is necessary, use clean water and expedite
drying with air movers or fans.
Shaw TOTALCARE® Hard SurfaceCleaneror equivalent floor cleaner are recommended for general spot and cleaning.
Avoid using mop and shine products on your resilient flooring.
Some disinfectants contain chemicals that can stain, discolor and cause general harm to your flooring product. Quaternary
Ammonium Salts are among those that have been found to be harmful to your flooring when used over time. Take care to
choose pH neutral products only.
SPOT & SPILL REMOVAL
Our flooring products are engineered to resist and minimize common staining.
Absorb wet spills as quickly as possible by blotting with paper or cloth towels. Rinse with water if necessary and blot dry.
Dried spots should be removed by gentle agitation and rinsed with water. Blot dry.
Use Shaw TOTALCARE® Hard SurfaceCleanercleaning products or products formulated for vinyl floor cleaning. Do not use
detergents or abrasive cleaners since these products can leave a dull residue.
Use rubbing alcohol (isopropyl alcohol) with a clean white cloth for spots requiring a solvent type cleaner that water and cleaning
agents cannot remove.
Please note that some stain conditions may become permanent.
Safety Caution: The surfaces of resilient floors change during wet cleaning and finish applications. Use appropriate safety measures.
2
For reference purposes only if printed or downloaded. Revision: 12092021
To Previous Page
Loading...