116
Sequence for setting a waypoint. Fig. 1: While traveling, press WPT
twice to call up the Find Waypoint screen (Fig. 2) and set a point. Fig.
3: A message says the waypoint has been saved. Fig. 4: vehicle
continues on its way; the waypoint number is visible on map.
NOTE:
The Quick Save method uses the default waypoint symbol until you
edit an existing waypoint and change its symbol. (Edit Waypoint
Symbol is described in Sec. 7.) After you have changed a waypoint
symbol, the unit will remember the one you chose and use it the
next time you "quick save" a waypoint. To revert back to the default
symbol, edit a waypoint and choose it, or use the Reset Options
command (described in Sec. 8).
Create Waypoint on Map
1. Use the arrow keys to move the cursor to a place where you want to
make a waypoint.
2. Press
WPT|WPT. The waypoint is saved and automatically given a
name with a sequential number, such as "waypoint 001." The waypoint
symbol and number appear on the map.
Fig 3.
Fig 4.
Fig 1. Fig 2.
To Next Page
Loading...
Need help?
General
