[1] Plug an Ethernet cable from your Router or
Network switch, into the Ethernet port at the
back of the Music Server.
[2] Plug one of the included audio cables from the
Music Server to the Amplifier (3.5mm Jack to
RCA cable).
[3] If required, connect the Trigger Outputs from
the Music server to the Line input of your
Amplifier (3.5mm to 3.5mm cable). The outputs
of the Music Servers are as follows:
[4] (Optional): Manual Setup Page: You can con-
figure the network settings directly on your
Music Server by connecting a USB mouse,
keyboard and monitor.
[5] Plug the power supply into the jack at the rear
of the Music Server.
[6] Start your Music Server by pressing the power
button.
A HARDWARE INSTALLATION
Loxone
Music Server
Quick Start Guide
www.loxone.com
To Next Page
Need help?
General