To Next Page

To Previous Page

Setting up

CG-6 Operation Manual p/n 115370001 Rev A

3—7

Note: If you enter a very high contrast offset value, you screen will be

very dark.

To enter the contrast offset value, move the cursor to the chosen character and press the

Enter button. To clear the entire field, move the cursor to the CLEAR field and press the

Enter button. To clear the last character that was entered, move the cursor to the

Backspace field and press the Enter button. Once you are satisfied with the value of the

contrast, move the cursor to the ACCEPT field and press the Enter button. To exit this

screen, move the cursor to CANCEL and press the Enter button.

Changing the value of your system time

The system time is the current time of your CG-6 Autograv

Note: You can also manually synchronize the system time in Julian Time

using the GPS signal. Please refer to Connecting the built-in GPS

on page 4-3.

To edit the value of your system time, move the cursor to System Time and press the

Enter button. The following screen will appear:

Figure 3-10 The system time editing screen

To enter the year, move the cursor to Year and press the Enter button. The following

screen will appear:

Questions and Answers:

Need help?

Do you have a question about the LRS SCINTREX AUTOGRAV CG-6 and is the answer not in the manual?

LRS SCINTREX AUTOGRAV CG-6 Specifications

General