www.lsracks.com
Page 2 of 2
12. Install fi ns (or Light Shelves, see Light Shelf installation
guide) individually so the pre-drilled hole in fi n aligns with
the threaded hole in post. (Diagram #5)
Note: Start installation from the lowest fi n location and
work up. This allows any gentle tapping from above if
required on snug fi tting fi ns.
13. Once key of fi n is installed and fi n is nested on post, secure
fi n by installing M2.5 bolt (supplied) and fi nger tighten with
2mm allen key.
Note: Use allen key only in orientation shown as to not
create excessive torque. Finger-tight is all that is required
to make a snug fi t. Use extreme caution not to over-tighten
and strip thread in post.
Note: Makita 1/4” Hex Driver Drill (model DF012D only) may
be used on torque setting 5 to tighten M2.5 bolts. The use of
other drill models and torque settings may over-tighten and
strip tread in post.
14. Repeat steps #12 and #13 until all fi ns/ light shelves are
installed. (Diagram #6)
15. Sit back and enjoy!
Diagram #4 :: Secure post to wall
Diagram #5 :: Install fi ns and components
Diagram #6 :: Keep on going!
CLASSIC SERIES INSTALLATION GUIDE
To Previous Page
Loading...