LSIS GIPAM 115 FI - Menu Navigation and Settings; Initial and Basic Menu Navigation

12
4.1
4.1 4.1
4.1 Relay part view
Relay part viewRelay part view
Relay part view
Distinguish whether protection relays are in use.
Setting value of secondary PT
Frequency setting status
A) Initial window
The initial window will be displayed as shown in below after applying the power supply to the device
R u n . . . 0 0 0 0 0 0
G 1 1 5 F I 6 0 H z / 1 1 0 V
B) The window of basic menu
If pressing SET/RUN key from initial window, move to basic menu window. It is the most fundamental window which
displays the lists of menu. DEC/INC key are used for the move of different menus and the detailed menu is available
by pressing ENTER key.
→ 1 . R E L A Y S E T T I N G
2 . M E A S U R E M E N T
↓
Press DEC key or INC key
↓
3 . E V E N T ／ F A U L T
4 . C O M M S E T T I N G
↓
Press DEC key or INC key
↓
5 . P T / C T S E T T I N G
6 . T I M E
↓
Press DEC key or INC key
↓
7 . S Y S T E M I N F O
The basic menu window of GIPAM-115FI is as shown in above figures. The menu will be selected if pressing ENTER key
after moving to the desirable menu by DEC/INC key.
4. MENU Setting
4. MENU Setting4. MENU Setting
4. MENU Setting