LSIS Master-K K1000S - W Irin G; Wiring Instructions; Wiring Examples

Chapter 16 Built-in high speed counter of K200S MASTER-K
16-4
16.4 Wiring
16.4.1 Wiring instructions
A high speed pulse input is sensitive to the external noise and should be handled with
special care. When wiring the built-in high speed counter of K3P-07CS, take the following
precautions against wiring noise.
1) Be sure to use shielded twisted pair cables. Also provide Class 3 grounding.
2) Do not run a twisted pair cable in parallel with power cables or other I/O lines which may
generate noise.
3) Before applying a power source for pulse generator, be sure to use a noise-protected
power supply.
4) For 1-phase input, connect the count input signal only to the phase A input; for 2-phase
input, connect to phases A and B.
16.4.2 Wiring examples
1) Voltage output pulse generator
Pulse Generator
CHSC
A
B
COM
24V
24VG
2) Open collector output pulse generator
Pulse Generator
CHSC
A
B
COM
24V
24VG