Chapter 14 Troubleshooting
13 -7
14.2.5 Action when PROGRAM WRITE does not work
Here describes the action procedure when PROGRAM WRITE does not work in CPU Module.
Program Write does not work
Yes
Put the key switch to Remote
STOP mode and run Program
Write.
Is the Run/Stop switch set as
STOP (Remote stop) mode ?
No
Is STOP LED
blinking ?
After releasing PLC connection
Off, read the error code
indicated when connected, and
modify it according to the
contents.
Yes
End
No
After Remote DIP S/W ON, run
Program Write.
Yes
No
Is DIP S/W of CPU
Module ON ?
To Next Page
Loading...