LSIS XGK-CPUU - Remote I;O System

Chapter 2 System Configuration
2 -11
2.4.2 Remote I/O System
This is the network system to control I/O module installed at far distance. Network system such as
Profibus-DP, DeviceNet, Rnet, Cnet etc is applied.
2.4.2.1 I/O System Application per Network Type
Remote I/O module is classified by base board type and block type (Smart I/O etc.) and there might be
the one that does not support base board type according to network.
Smart IO
Network type (master)
Block type Expansion type
Profibus-DP
O O
DeviceNet
O O
Rnet
O O
Modbus(Cnet)
O
-
FEnet
- O
Ethernet/IP
- O
RAPIEnet
- -
* The above description is subject to change for function improvement. For correct information,
please refer to each network system manual.
Max. no. of installation and max. no. of module per service is the same as local network.
In case that I/O module and Special module are installed together in Rack type Remote, one remote
master module shall use 1 high speed link and 1 P2P.
2.4.2.2 Block Type Remote I/O System
1) System Configuration
This system is configured by Profibus-DP, DeviceNet and Rnet and it is available to use block type
Remote I/O regardless of the series. Profibus-DP and DeviceNet were developed based on
International Standard which enables to connect with Smart-I/O of our company as well as the
product of other manufacturer.
• Master module is available to install up to max. 12 and also available in the expanded base.
2) I/O allocation method and I/O no. assignment
• It is available to allocate ‘P’, ‘M’, ‘K’ and ‘D’ device to Remote I/O by high speed link parameter.
‘P’ area is recommended to use the forced ON/OFF function and initial reset function.
• Max. available point of I/O device (P area) is 32,768 point(P00000 ~P2047F).
• For the setting method of high speed link parameter per module, please refer to XG-PD manual.
XGP-ACF1
XGK−CPUH
XGL−****
Pnet/Dnet/Rnet
Master module
Main base
Smart-I/O Smart-I/O Smart-I/O