LSIS XGT Series - Page 548

Chapter 9 NC Control Function
9-45
20) Single direction positioning (G60)
G90 G60 X_ Y_ Z_ U_
G60: Single Direction Positioning command
G00: Positioning command
X_ Y_ Z_ U_: Target position to traverse
Single Direction Positioning (G60) is the function used for tool traversing, which replaces the Rapid Traverse or runs
last. After stopping at the position separated by the overrun stroke set for the commanded positioning direction, it
moves to the end position and obtains the effect of backlash compensation.
Therefore, the G60 command is applied, it always moves from the same direction to the target position.
The overrun amount is stored in the parameters.
Please refer to the overrun feed amount of the single direction positioning of NC channel / axis parameters.
NC parameters
Group name and parameter name
NC channel/axis parameters
Note that the single direction positioning command does not eliminate the backlash physically.