Appendix 2 Error Information & Solution
Appendix 2 Error Information & Solution
Here describes the information error types and its solutions.
(1) Function block error information
Error Description Solutions
The current motion controller does not support the
function block.
This command is not performed in the current version of the
controller. Please contact customer support team of our company
after checking the version in which the command can be
The axis number (Axis input) or encoder number
(Encoder input) of the function block exceeded the
Set the axis number to be 1~36. (Encode number: 1001~1002)
The axis group number (AxesGroup input) of the
function block exceeded the allowable range.
Set the group axis number to be between 1 and 16.
0008 8 The NC channel of the function block exceeded
Check the range of the NC channel and set it again.
0009 9 The slave number (Slave input) of the function
block exceeded the allowable range.
Check the range of the slave number and set it again.
000B 11 The input of the function block exceeded the
Check the input range of the function block and set it again.
000C 12 The array input of the function block exceeded the
Check the size of the array input of the function block and set it
0012 18 Error block internal execution error occurred
during execution of the function block.
The problem can arise in the current controller version. Please
check the support version of XG5000 and controller.
Motion response error occurred during execution
of the function block.
The problem can arise in the current controller version. Please
check the support version of XG5000 and controller.
It exceeded the allowable range of the cam
ID(CamTableID input) of the function block.
Check the range of the cam ID and set it again.
To Next Page
Loading...
