LSIS XGT Series - Page 837

Appendix 2 Error Information & Solution
A2-3
(3) Data log, SD additional function error information
Error code
Error Description Solutions
Hex
Dec
Overall Error Code
0001
1
SD Card Recognition Error
Format it to FAT32 and connect to SD memory
0002 2 Partition Information Error Format it to FAT32 and connect to SD memory
0003
3
File System Error
Format it to FAT32 and connect to SD memory
0004
4
Unsupported SD Card
Connect SD card with a capacity of 2GB to 32GB
0005
5
SD Card Capacity Check Error
The SD memory capacity test failed, and thus DS cannot be
used. Replace SD memory or re-connect it after formatting
0006
6
SD Card Capacity Excess
SD memory capacity is used up, and data storage is not
possible. Replace SD memory or re-connect it after formatting. If
the available capacity is less than 20%
0007 7 Folder Creation Failed Failed to create data log folder in SD. Replace SD memory or re-
connect it after formatting
Error Code by Data Log Group
1000
4096
Group x Folder Creation Error
Format it to FAT32 and connect to SD memory
2000
8192
Group x File Open Error
Format it to FAT32 and connect to SD memory
4000 16384 Group x File Write Error Format it to FAT32 and connect to SD memory
SD Additional Function Error Code
0001
1
File Error(File Open Failure, CRC Error)
Operate it after creating the file again
0002
2
Damaged File (Damages to Head and Tail, etc.)
Operate it after creating the file again
0005 5 No Password in File The password is set in the PLC, but there is no password in the
file stored in the SD card. Set the password and create a file.
0006 6 Password Mismatch The password set in the PLC does not match the password of
the file stored in the SD card. Confirm it again after checking the
password.
0007
7
MAC Address Mismatch
The set MAC address does not match the MAC address of the
PLC. Check the MAC address and reset it.
000A
10
No Saved File
There is no file saved in the SD card. Operate it after creating a
file.
000B
11
PLC Mode Is RUN State
Check it after switching PLC mode to STOP.
(4) Analog error information
Error code
Error Description Solutions
Hex
Dec
0064
0100
Range setting error of input channel 0
Set the range that can be set
0065 0101 Range setting error of input channel 0 Set the range that can be set
00C8
0200
Filter value setting error of input channel 0
Set the filter value that can be set
00C9
0201
Filter value setting error of input channel 0
Set the filter value that can be set
012C
0300
Average value setting error of input channel 0
Set the average value that can be set
012D 0301 Average value setting error of input channel 0 Set the average value that can be set
0190
0400
Range setting error of output channel 0
Set the output range that can be set
0191
0401
Range setting error of output channel 0
Set the output range that can be set
01F4
0500
Input value setting error of output channel 0
Set the input value that can be set
01F5 0501 Input value setting error of output channel 0 Set the input value that can be set
0258
0600
Interpolation method range setting error of output channel 0
Set the interpolation method range that can be set
0259
0601
Interpolation method range setting error of output channel 0
Set the interpolation method range that can be set