4.1 Touch Calibration
When the location is not recognized in XGT Panel, Touch’s scale can be adjusted in XGT Panel. If you press [Touch Calibration]
button in System Configuration, the setting screen shows up. If you press five ‘+’ marks, XGT Panel’s touch location adjustment is
completed.
If you press two points simultaneously while [Allow Multi-touch] is selected, XGT Panel recognizes as if middle point between two
points is selected. If you press two points simultaneously while [Allow Multi-touch] is not selected, XGT Panel recognizes as if any
point is not selected.
Remark
(1) XGT Panel’s Touch Calibration setting is basically set. If Touch location error is big, adjusting menu with touch can be
hard through touch. In that case, You can select the Touch Calibration setting menu by USB mouse.
(2) When touch location changes in using, redo touch setting.
(3) If you don’t allow Multi-touch, sensitivity is lower than when allowing Multi-touch.
To Next Page
Loading...
