Against the surge and lighting, use the surge absorber as follows.
Remark
(1) Separate the surge absorber’s ground (E1) from XGT Panel’s ground (E2).
(2) Select a surge absorber so as not to exceed the maximum permissible voltage of a surge absorber even if power
voltage rises to maximum
When noise invades, use the insulation shield Trans or noise filter.
Strand input power cable with minimum length and make sure the shield Trans or noise filter is not crossed above the duct.
It is recommended to attach a ferrite core in power section when using Magnet Switches.
ex) Attach ferrite core on power section as shown in the illustration.
E2
To Next Page
Loading...
