Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-35System Renumbering
3
Procedure: Specifying New Extension Ranges 3
Console Display/Instructions Additional Information PC
! Select the System Renumber menu.
! Select Non-Local UDP renumbering.
! Dial or type the first number in the range.
! Go to the next step.
Select
(QWHU.

!
CAUTION:
!
CAUTION:
Pressing (QWHU does not save information until Step 10 of this procedure.
6\VWHP3URJUDPPLQJ!
0DNHDVHOHFWLRQ
6\VWHP ([WHQVLRQV
6\V5HQXPEHU 2SWLRQV
2SHUDWRU 7DEOHV
/LQHV7UXQNV $X[( TXLS
([LW 1LJKW6UYFH

6\VWHP5HQXPEHU
0DNHDVHOHFWLRQ
'HIDXOW1XPEHULQJ
6LQJOH
%ORFN
1RQ/RFDO8'3
([LW

1RQ/RFDO8'3
If the number conflicts with an existing
(QWHUVWDUWLQJQXPEHU
number on the local system, or it is not the
beginning number of an existing range and

is within a range for a remote system,
check the system planning forms and try
%DFNVSDFH
again.
([LW (QWHU
SP: “Entering an Extension”
Ã

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English