Form A: System Configuration
PAGE
3 of 3
13. Installation Date 14. Order Nos.
15. Sales Support Representative’s Name
Telephone No.
11. Auxiliary Equipment (System). Check if applicable:
■■ Battery Backup
■■ Caller ID Devices
■■ Loudspeaker Paging: Number of zones ______________
■■ Magic on Hold (Music on Hold {#602} must be active.)
■■ Uninterruptible Power Supply
■■ SMDR If checked, specify the following if appropriate:
• SMDR Record Type {#608}—By default, all calls are included on call reports. Write
“Out” if only outgoing calls are reported _________.
• SMDR Output Format {#610}—By default, up to 15 digits are printed for dialed
numbers in the Number field of the call report. Write “24” if a maximum of 24 digits
is desired _________.
• SMDR Talk Time {#611}—By default, a Talk field is not included on the call report.
Write “Active” if the Talk field is desired_________.
■■ PARTNER Contact Closure Adjunct. If checked, write in the number (1–4) below to
specify Operation Type for each Contact Closure as appropriate:
1 = 1 second on
2 = 3 seconds on (✓)
3 = 5 seconds on
4 = Toggle
OperationType
{#613}
Contact
Closure 1
Contact
Closure 1
■■ Backup/Restore PC Card. If checked, write “Active” if Automatic System
Programming Backup {#123} is desired _________.
ASA/DXD PC Card
PARTNER Voice Messaging PC Card
12. Notes: Write any additional information that you want to communicate to the installer.
Required for PARTNER Advanced Communications System.
For additional instructions, see page 4.
To Next Page
Loading...
