Use steps
1.
Make sure the battery is charged and tire is filled with enough air (20 PSI max)
2.
Press the fourth button with the lightning mark on the anti-theft device twice ,e-
bike make "Do-Re-Mi" sounds, then the motor will be started.
3.
Press the switch button next to the left handlebar to complete the start.
4.
Set the gears on the meter to 1-5, turn the throttle to ride. Select a Pedal Assist
(PAS) level using the plus(+) and minus(-) buttons. PASO provides no motor
assist. PAS 1 is the lowest level of assist and PAS 5 is the highest level of assist.
5.
After riding, press the lock button on the anti-theft device will turn off the
motor. At this time, if someone touches our e-bike, an alarm will sound, and then
press the second unlock button to release the alarm
6.
lf you want to find where the e-bike is, please press the third find button of the
anti-theft device, and then the e-bike will beep.
7.
lf you want to ride again, press the second unlock button and the e-bike will
start again
四
15
To Next Page
Loading...