SERVICES
36
2. Remove any water filters fitted, and
replace with a short length of hose or
empty filter cartridge (this will ensure the
filter is not affected by the disinfectant/
sterilant solution).
3. Fill the system by using the pump with a
disinfectant/sterilant solution. (Check that
the solution at full strength appears at all
taps/showers). Allow to stand for the
recommended period of time.
4. Drain the system down using the water
systems internal flip switch located under
the front off-side bed.
5. Thoroughly clean the outside of all taps/
connectors with a cloth soaked in the
disinfectant/sterilant.
6. Flush the system through with clean
drinking water until no traces of
disinfectant/sterilant can be detected at
any tap.
7. Replace the filter.
Suitable sterilising chemicals are available
from your caravan dealer, accessory shop,
chemists or home-brew shops. It is not,
however, recommended to use bleach or
sodium metabisulphite.
Setting Up the Water System
1. Replace/close all drain valves.
2. Replace shower heads and tap spouts.
3. Close all taps.
4. Refit old filters:
a. Check all plumbing connections.
b. It is recommended at this point to
sterilise your water container and
flush the system through with
sterilising fluid.
Note:
Frost damage cannot be claimed under
warranty.
To Next Page
Loading...
