53
TRUMA COMBI BOILER
TRUMA CONTROL PANEL
Operating Information
Power selector switch
a = Power selection rotary
switch
b = Electric operation
230V, 1800 W
c = Electric operation 230V,
900W
d = Gas operation
e = Mixed operation*
(900W gas and
electrical operation)
f = Mixed operation*
(1800W gas and
electrical operation)
g = Yellow LED on =
"Electrical operation"
* Winter mode only!
In summer mode the unit automatically selects electric
operation at the preselected electrical power of 900W
or 1800W.
Control panel
h = Rotary switch for room temperature (1-5)
k = green LED lit "Operation" green LED blinking
"after-running" is active in order to reduce the
unit's temperature
l = Summer operation
(water temperature 40ºC or 60ºC)
m = Winter operation
(heating without water temperature monitoring or
with drained water system)
n = Winter operation
(heating with water temperature monitoring)
o = Rotary "Off" switch
p = Yellow LED lit = "Boiler heat-up phase"
r = red LED lit, red LED blinking "Failure"
Filling the Water Heater
• Check if the rotary switch for the drain
valve is set to ‘Operation’, meaning that it
is parallel to the water connection and
engaged.
•Close the drain valve by pushing the
push button until it engages.
• Switch on power for water pump .
• Open hot water taps in kitchen and
bathroom. Leave the fittings open for as
long as it takes for the boiler to displace
the air and fill up, and the water to flow
without interruption.
For more detailed information on operating
the Truma Combi boiler please refer to
TRUMA appliance instructions that can be
found in your information wallet.
It is essential that you do not block/
obstruct or cover the flue outlet from your
Truma Combi Boiler.
To Next Page
Loading...
