116
by Lutron
Adjusting Low-End Trim on a Caséta Diva Smart Dimmer (DVRF-6L)
Diva Smart dimmer
On
Off
Adjust
• Slide to adjust light level
• Will not turn lights Off
Soft-glow light bar
Adjusting Low-End Trim -
To optimize performance of dimmable LED lamps
1
Pull the Front Accessible Service Switch (FASS) out
to the open position
2
Press and hold the OFF button
3
Continue to hold the OFF button and push the FASS
in to the closed position. Continue to hold the OFF
button for approximately 6 seconds until the light bar
starts flashing.
6
Verify
Test low-end setting and repeat steps 1-4 as needed to set the
desired level.
5
Save
UNTIL
HOLD
0
5
10
15
6
sec.
The light bar
starts flashing
Note: Low-end trim will also be available in the app
Tap the OFF button to save
the setting
4
Adjust the low-end level
Release the OFF button
and use the slider to adjust
the low-end level.
To Next Page
Loading...