119
by Lutron
Setting Dimmer Phase on a Caséta Wireless ELV+ Dimmer (PD-5NE) Removing Paired Pico Remote Controls from a Caséta Wireless Dimmer (PD-6WCL / PD-10NXD / PD-5NE/PD-3PCL)
1
Tap the "On" button quickly at least three times,
holding on the last press
0
5
10
15
3
sec.
2
Continue to hold the "On" button until the light
begins to flash quickly
UNTIL
3
Release the button, then immediately tap the button
at least three more times and release
Light will flash slowly
three times, then turn off
4
All paired Pico remote controls are removed and all
settings are returned to factory default
– After the dimmer resets, the light will turn on to the full on state.
NOTE: This procedure also resets the high-end and low-end trim
settings.
HOLD
HOLD
Light starts
flashing quickly
3x
TAP 3x and HOLD
TAP 3x
TAP 3x
TAP 3x
OR
OROR
To Next Page
Loading...