73
by Lutron
Multi-Location Installation - Caséta Wireless Switch with Pico Remote Controls (PD-5WS-DV) Multi-Location Installation - Caséta Wireless Neutral Switch with Pico Remote Controls (PD-5ANS/PD-6ANS)
1
Identify existing wiring
2
What you need for a multi-location installation
WARNING! Shock Hazard. May result in Serious
Injury or Death. Turn off power at circuit breaker
before installing the unit.
4
Turn power off at circuit breaker
5
Remove existing switch from wall at Location 1
- If one switch controls the lights (single-pole installation)
See quick-start guide that came with your switch
- If two switches control the lights (3-way installation)
See page 15 or page 41 for details
Important note:
3
Choose a location for your Caséta Wireless switch
NOTE: There will be two different types of existing switches in this
application. Locations 1 and 3 will use 3-way switches (three screws
which control the lights, plus one ground screw) and Location 2 will use
a 4-way switch (four screws which control the lights, plus one ground
screw). For easiest installation, we recommend replacing one of the 3-way
switches with your Caséta Wireless switch (Locations 1 or 3). In this
example, we will use Location 1.
Location 1
3-Way Switch
(Locations 1 and 3)
4-Way Switch
(Location 2)
Three or more switches control the lights
(multi-location installation)
Location 1 Location 2 Location 3
+
Switch
PD-5ANS/PD-6ANS
Two Pico
remote controls
PJ2-2B
Two wallplate brackets
PICO-WBX-ADAPT
+
Three Claro wallplates
CW-1
+
To Next Page
Loading...