Lutron Electronics Sivoia QS roller 100 - Mount Shade to Sub-bracket; Remove Shade Bracket Screws; Lift and Hook Shade Brackets; Swing Shade Down

6
6.1
Mount shade to sub-bracket
Remove retaining screws
from shade brackets.
6.2
Lift shade up into pocket.
Hook the lip of each
shade bracket onto the
top of each sub-bracket.
Note: Partial cutaway
shown in pocket.
6.3
Swing shade down until
bottom of shade brackets
rest against sub-brackets.
Note: Ensure cable is
kept outside the shade
bracket.
6.4
Final position -
Note placement of cable.
NOTICE: Shades wider than 4 ft (1.2 m) require two people to install.
Note: If installing a coupled shade system, install the shade with the EDU first.
Note: Leave protective wrapping on shade during installation.
Page 10
Sivoia® QS roller 100TM Pocket Mount Installation instructions