LuxaFlex PowerView Motorisation - Step 6: Install Repeaters; Plug In Repeater and Observe Status; Repeater Placement and Quantity Guidelines; Pair Repeater Using PowerView App

INSTALL REPEATERS
STEP 6 INSTALL REPEATERS
6.1
PLUG REPEATER INTO WALL OUTLET
The LED blinks AMBER, indicating the Repeater has power,
but has not yet been joined to a PowerView® Shade
Network.
- Be sure the wall outlet has power.
- No more than six Repeaters should be used in a home,
unless otherwise instructed by a Luxaflex® PowerView®
Motorisation specialist.
- Do not place Repeater in direct sunlight.
6A
PAIR REPEATER TO POWERVIEW®
SHADE NETWORK IF USING
POWERVIEW® APP
- Open the PowerView® App and select
“Device - Discovery.”
- Follow the on-screen instructions to set up each
Repeater. The Repeater LED turns solid BLUE to indicate
the Repeater has been paired to the network. Follow
in-app instructions to assign a custom Repeater LED
colour, if desired.
11