LuxaFlex PowerView Motorisation - Pair Repeater with Remote Network; Initiate and Confirm Repeater Pairing Process

INSTALL REPEATERS
12
6B
PAIR REPEATER TO POWERVIEW®
SHADE NETWORK IF USING
POWERVIEW® REMOTE
- Press and hold STOP on the remote that was used to
create the PowerView® Shade Network until the lights on
the remote flash (approx. 6 seconds).
- With the remote no more than 3 feet from the Repeater,
press and release STOP.
- The Repeater blinks BLUE three times to signal it has
been joined to the network. After the blinking stops, the
Repeater is still active.