LuxaFlex Roller blinds series - Mounting Packing Profiles; Fitting the Cassette; Mounting and Screwing Side Channels

3. Mounting the packing profiles for 100 or 105° frames
(only if packing profiles supplied)
• Place the packing profile with the stop against
the frame [1].
• Screw the packing profiles into place [2].
4. Fitting the cassette
• Taking the cassette in both hands and push
it up into the mountingbrackets.
• The front lip at the top of the cassette should
now be sitting flushwith the frame.
(Gebruik bij rolgordijnen de meegeleverde
handschoenen om het risico van vlekken op
de stof te voorkomen).
5. Mounting the side channels
• Slide the channel under the cassette on each side [1].
Warning:
- Make sure that you locate the end guide of the
bottom bar intothe groove of the channels.
- Check that you have not trapped the cords
between the frame andthe channels.
• Position the channels against the frame [2].
6. Screwing the side channels onto the frame
Use enough screws to fill all the holes
predrilled in the side channels.
2 - 4Skylight Products
Assembly and Operating instructions