LuxaFlex Roller blinds series - Removing Transport Cord Cleat; Mounting Cord Tension Clips; Assembly Options; Centre Tension Cable for Venetian Blinds

7. Removing transport cord cleat
• Remove the cords from the transport cleat.
• Remove the transport cleat and keep it in a
safe place, as it will beuseful if you need to
8. Mounting cord tension clips
Clip both cord tension clips into the holders at the
bottom of each sidechannel.
Warning: For Duette® and Plissé shades,
ensure that the cords are not twisted.
Assembly Options
9. Centre tension cable for venetian blinds
(Only supplied with wide Luxaflex® Venetian blinds)
dismantle the product.
• Place the side guiding sill bracket [1] so that
its opening is directlybelow the groove in the
bottom bar [2
].
• Mark the position of the sill bracket, and screw into place.
and screw into place.
• Slide the locking ring onto the cable with its wider rim at the bottom,and pull the cable tight to
• Slide the locking ring up by approximately 20 mm from the bottomof the frame and tighten
• Pull the cable down and locate the locking ring under the sill bracket.
3 - 4
• Pull down the blind completely.
the grub screw to secure.
remove any slackness.
Skylight Products
Assembly and Operating instructions