Need help?Do you have a question about the Lyngdorf CD-2 and is the answer not in the manual?
Configures the serial port with 8 data bits, no parity, one stop bit, and a baud rate of 115200.
Details the structure of commands and requests, including start/end characters and parameters.
Requests the software version of the CD-2 player.
Requests the current operational state of the CD-2 player.
Requests the number of the track currently being played.
Requests the total number of tracks on the current disc.
Requests the elapsed time of the currently playing track.
Requests the remaining time of the current track.
Requests the current playback mode (e.g., normal, repeat).
Requests the track name from CD-text information.
Requests the track artist from CD-text information.
Requests the disc name from CD-text information.
Requests the disc artist from CD-text information.
Commands for powering on/off, toggling power, and ejecting the disc tray.
Commands for play, pause, stop, previous/next track, and scanning.
Commands to set play mode, display mode, and sample rate.
Commands to adjust analog output gain and manage status/text subscriptions.
Details the pinout for the RJ12 connector used for the RS232 cable.
To Next Page
General